Installation Manual

Installing the Switch
Cup Cover/Light Kit/
LED Bulbs/Wire Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit to
the fan before installing the light kit.
1. Remove one screw from the black bracket from
the fan motor assembly. Loosen, but do not
remove the other two screws. Align the key
hole slots in the switch cup adaptor with the two
screws in the black bracket. (Figure 15)
2. Turn the switch cup adaptor clockwise until the
two screws are situated in the narrow end of
the keyholes. Re-install the one screw that was
removed in step 1. Tighten all screws rmly.
(Figure 15)
3. Remove three screws from the switch cup
adaptor. Connect the molded adaptor plug in the
switch cup with the molded adaptor plug of the
fan motor assembly. (Figure 16)
4. Install the three screws that were removed in
step 3. Tighten all three screws rmly. (Figure
16)
5. With the power off, install the two LED bulbs
(provided) into the light bulb sockets. (Figure
17)
6. Remove the nial from the threaded nipple of
the light kit tter assembly. Position the wire
shade over the threaded nipple. Re-install the
nial to the threaded nipple properly. (Figure 18)
Switch
Cup Adaptor
Upper Plug
Connector
Mounting Screw (3)
Reverse switch
Switch cup
Mounting
screw (3)
Upper plug
connector
Finial
Lower plug
connector
Figure 15
Figure 16
10.
Figure 17
Socket
LED Bulb
Finial
Wire Shade
Figure 18