Assembly Instructions

Carefully unpack all lamp parts from the carton.
1.Take the lamp carefully out of the Carton,and place it on a flat surface.
2. Be sure the power to the installation point is power off
3.Fasten the Crossbar to the outlet box . Locate the Nipple and thread into the center of the Crossbar.
4.Locate the Fixture Chain、Ceiling Canopy、Canopy Chain Loop、and Canopy Lock ring. Pass the
Fixture Supply Wire and Ground Wires through in the following order: 1)Alternate Fixture Loops in
the Fixture Chain; 2)Canopy Lock ring; 3)Canopy Chain Loop; 4)Ceiling Canopy.
Finally,proceed to pass the wires through the Nipple attached to the Crossbar.
5.Thread the BT58 Edison Bulb (Included) onto the Socket. Hand tighten until snug
ASSEMBLY INSTRUCTIONS