Instruction Manual

28 •
••
• Setup and Utility Menus
until the recording ends. Any interruption or change will terminate the record-ready mode, or the
recording itself.
In some cases, the source machine may require time to stabilize. It may be helpful to pre-roll and start
the source before placing DigiCart into record, or to pause a CD player before recording, rather than
commencing record and then starting the source player from a standstill.
R ECORD T IME L IMIT
• NONE
• 30 SEC
• 1 MIN
• 5 MIN
• 30 MIN
• 60 MIN
Enhances the management of available Disk space of DigiCart/E and accelerates entry to the Record Ready
condition when set to smaller values. Furthermore, you can start a recording and walk away knowing that
after the specified time limit (setting +5%), the unit will stop recording.
S ET A UX P ROTOCOL
• ES-BUS
• PERIPHERAL-BUS (GV)
• PERIPHERAL-BUS (SONY)
Defines the serial protocol for the AUX serial port on the rear panel. See Appendix B for Serial Protocol
documentation.
S ET C ONTRAST
• 0 to 100
Adjusts the LCD contrast. Select a value that works best for your viewing angle and lighting conditions.
S ET H EADPHONE L EVEL
• 0 to 64 (1 db per step)
Adjusts the volume for the ¼” headphone jack on the front panel. Select a value.
S ET I NPUT M ONITOR
• OFF
• ON or DISABLED BY D-NET
Allows you to monitor audio that has been processed through the digital audio circuitry.
Digital monitoring cannot be accomplished if the D-NET receiver is enabled. The message, “Disabled by
D-Net” will appear to advise you that the input monitor cannot be turned on.
NOTE: DigiCart/E automatically provides "pass through" A/D - D/A audio when the REC button is pressed.
Therefore, most operations may be accomplished with the INPUT MONITOR: OFF.