Instruction Manual

78 •
••
• D-Net File Transfer
If you set “*” only as the destination name for a transfer, the transfer will be made to every DigiCart that is
enabled to receive transfers. Setting the receiver name to “MAILBOX ONLY” will still block direct access
transfers.
Transfer Messages
S OURCE M ACHINE D ISPLAYS
Incomplete Transfer
After a brief error message the display alerts that the transfer was incomplete.
Press ENTER or EXIT to acknowledge the message.
The display will show the number of files transferred without errors as “FILES SENT”, and the
number of files not sent.
This signifies the number of files transferred without errors and the number of files not sent due to
errors.
Errors in a transmitting unit are extremely rare and indicate a hardware problem in the unit itself not in the
D-NET connections or in the receiving unit.
A BORTED T RANSFER
If you press the EXIT or STOP buttons on the source DigiCart during a transfer, the transfer will continue to
proceed while the display queries “QUIT TRANSFER? PRESS ENTER/EXIT”
If you press the EXIT button, the display will revert to normal and the transfer will continue.
If you press the ENTER button, the transfer is aborted and the display briefly shows:
“TRANSFER ERROR, CANCELLED BY USER”
followed by:
“TRANSFER INCOMPLETE, PRESS ENTER/EXIT”
R ECEIVING M ACHINE D ISPLAYS
Display During Transfer
If the receiving DigiCart is idle and the receiver name matches the Destination Name on the source
DigiCart, when a file transfer begins, the display indicates transfer status in the number of files transferred
and percent complete for that file.
When the transfer completes without errors, for a few seconds the display shows:
“TRANSFER COMPLETE, NO ERRORS”
Then the display shows:
“GOOD FILES: NN, BAD FILES: NN”
This indicates the number of files received without errors and the number of files discarded due to errors.
This message will only appear after multi-file transfers.