User guide

36 • Operating Instructions DigiCart/II Plus Owner's Manual

UP ARROW SELECT KNOB CW SELECT KNOB CW

DOWN ARROW SELECT KNOB CCW SELECT KNOB CCW

LEFT ARROW

LEFT POSITION

ARROW

LEFT POSITION ARROW

RIGHT ARROW

RIGHT POSITION

ARROW

RIGHT POSITION ARROW

ENTER / RETURN ENTER ENTER

ESCAPE CANCEL CANCEL

0 - 9

INDEX NUMBER

LOCATORS

INDEX NUMBER LOCATORS

SCROLL LOCK PRESETS PRESETS

NOTES:

1. Not all "AT" keyboards will work with DigiCart/II Plus.

2. If you connect the keyboard (or another remote control) after power-up, press SEC

and the DNET XFER button together to re-initialize the system.

3. If the keyboard selection is incorrect, the function keys will not line up with their

assigned function.

Remote Control

Selects whether the rear panel Serial Port connector is active. When REMOTE control is set to

INACTIVE, DigiCart/II Plus will not respond to remote control serial interface commands. To

activate remote control, you must select an ADDRESS (1 - 32) to establish communication between

DigiCart/II Plus and a host computer/automation controller connected to the port. Addresses 1 to 4

correspond to the four machine control buttons on the 360 Systems RC-220 Remote control. The

RC-210 requires a setting of address 01.

It is recommended that Remote Control remain set to INACTIVE if not in use. If you intend to use

DigiCart/II Plus with an automation system that requires serial communication, consult with the vendor of

that system to determine the correct setting for this function. For more details on DigiCart/II Plus's remote

control capability, refer to CHAPTER TWO – pg. 19, Serial Control.

1. Press the SETUP MENU button and use the selection controls to choose and

confirm your selection:

REMOTE CONTROL

INACTIVE

REMOTE CONTROL

ADDRESS XX

Cart Spindown (Time-Out)

Determines if the Cart Drive will remain active and on-line or "Time-out" after 30 minutes. When

set to ON, if the Drive is not accessed for 30 minutes it will spin down to save wear and prolong its

life span. A setting of OFF causes the drive to run continuously. We strongly recommend leaving

Cart Spindown ON.