Manual

____________________________________________________________________________________
Page 100 MAXX 2400 Owners Manual
power supply switch to shutdown the Image Server. Shutdown the system only by momentarily
pressing the front panel power button or selecting Start > Shutdown > Shutdown from the
graphic user interface.
A degraded array with a drive listed as “Not In Service” or “Inaccessible” is usually indicative of a
permanent drive error, typically a single disk or cable failure, but redundant data will allow normal
operations to continue. You may first try to rebuild the array with the existing drive still installed.
If the array continues to indicate a failed drive, replace the drive and then rebuild the array. A
hard disk array must be repaired using exactly the same drive model and capacity as other drives
in the array. Because specific drive models become unavailable as time goes on, 360 Systems
recommends that maintenance spares be purchased at the same time as the Image Server.
Log-In to the RAID Utilities
Figure 42 - RAID Utilities Login Screen
To log in to the RAID utilities, perform the following steps. The above drawing will appear.
• Open the RAID utilities by selecting START>SYSTEM>RAID STATUS
• In the Login window, enter ADMINISTRATOR.
• In the Password window, make no entry; leave it blank. In the event this does not work,
use the password “3ware”.
• Click the Login button to enter the Login Utilities.