ADSL Modem Ethernet Installation Guide

1-8 CHAPTER 1: INTRODUCTION TO THE HOMECONNECT ADSL MODEM ETHERNET
Enable the port using the command:
enable port <port #>
Save the configuration using the command:
save all
For example, if your service provider instructed you to use
VPI 0 and VCI 44, you would enter the following CLI
commands:
set port 2 vpi 0 vci 44
enable port 2
save all
The CLI provides extensive configuration and monitoring
capabilities. For more information, install the CLI User’s
Guide from the Installation CD supplied with your unit.
Operation
After you have properly connected your HomeConnect
ADSL Modem Ethernet, and your new DSL link has been
activated by your Network Service Provider, all you need to
do is enjoy the high-speed DSL access to your network.
There are no controls or adjustments to make. Just make
sure that power is provided to your ADSL Modem Ethernet
at all times, and that adequate ventilation is maintained.
The unit will take one minute to boot up when you power
it on. If power to the unit is interrupted, the ADSL Modem
Ethernet will automatically reconnect to the network when
power is restored. The connection process is not
instantaneous, however, and it may take several minutes
for your service-provider’s central-office equipment to
perform its periodic check of your line and then do the
necessary “handshaking” to restore full communication.
LED Indicators
There are four indicator lights (LEDs) on the front of the
ADSL Modem Ethernet. The Alert and ADSL status can light
red, orange, or green, depending on the status of the unit.
The PWR and LAN Status LEDs can only light green.