Server User Manual

3-6 C

HAPTER

3: S

TARTUP

12 Insert the master (source) diskette (the diskette you want to copy from)

and press the Return key.

The server copies files from the master diskette. The following message

appears:

reading...OK

insert copy and hit return to continue

13 Remove the master diskette.

14 Insert the formatted copy (destination) diskette (the diskette you are

copying to) into the diskette drive and press the Return key.

A message similar to the following appears during and after copying:

writing...verifying...OK

Copy another disk? (y/n):

If you want to copy another diskette, type

. If you do not want to copy

another diskette, type

15 When the copy procedure is completed, remove the newly created

diskette and label it with the software version.

Store the original diskette in a safe place, and use a newly created

diskette as your working diskette. Make sure the working diskette is not

write-protected.

Once you have copied your diskettes, you are ready to start the server.

Refer to “Booting the Communications Server” on page 3-7 for the

procedure.

Formatting Diskettes without the Copy Command

You can also format diskettes without the copy command by using the

following procedure:

1 Enter monitor mode by following steps 1 through 7 in the previous copy

procedure.

2 To format a diskette, enter the format command:

The following message appears:

Insert diskette to be formatted

CS2500BookFile : Startup Page 6 Thursday, December 11, 1997 10:44 AM