Server User Manual

Shutting Down 3-9
1 Notify all users that the server is being shut down.
You can notify users from a terminal port on the server or from the
console via the BRoadcast command. Refer to the
Multiprotocol
Communications Server Operation Guide
and
Multiprotocol
Communications Server Software Reference Guide
for information on
this command.
2 Disconnect all active sessions.
Refer to the
Multiprotocol Communications Server Operation Guide
and
Multiprotocol Communications Server Software Reference Guide
.
3 To shut down a CS/2500, turn the power off. On a CS/2600, wait until
the disk drive LED goes out, then turn the power off.
If the disk drive LED remains on, enter monitor mode by pressing the
hardware interrupt switch and the Return key on the console keyboard.
If the disk drive LED remains on after you press the hardware interrupt
switch, perform a soft reset by entering
k
at the monitor prompt (>).
If the disk drive LED remains on after you enter the soft reset command,
do the following:
a Eject the diskette.
b Turn off the server.
c Contact 3Com or your network supplier.
CS2500BookFile : Startup Page 9 Thursday, December 11, 1997 10:44 AM