Server User Manual

Changing the Configuration 4-3
Changing the
Configuration
To change the communications server configuration, follow this
procedure:
1 Enter the firmware configuration command
fc
at the monitor prompt.
The following menu is displayed:
2 Type
D
to display current parameter settings.
The following display shows factory default settings for the CS/2600
(except for Ethernet address, which is only an example):
Default settngs for the CS/2500 are the same, except that Initial Boot
Source is “Network.”
3 To return to the Firmware Configuration Utility menu, press the Return
key.
Firmware Configuration Utility
Commands:
C - Change parameters
D - Display parameters
es
c
- Exit to monitor
Current Parameters:
Ethernet address 080002025DAC
Console baud rate 9600
Console port 0
Continuous self-test Disabled
Auto-reboot Reboot only
Monitor Disabled
Initial boot source Floppy then Network
Number of reboots 00
Network boot string _cs200
Boot retries Try Forever
Boot protocol SLP
Number of ports 10
Default memory map CS/2500/2600
RS-232 ports 0 1 2 3 4 5 6 7 8 9
RS-422 ports
Auto RS-422 select Disabled
LF issued after CR YES
Printer setup string:
CS2500BookFile : Configuration Page 3 Thursday, December 11, 1997 10:44 AM