Dishwasher User Manual

These commands control the current system settings. These commands are available when the
projector is in Standby mode and when it is on.
Command Command target range Response
set restoredefaults [none] restoredefaults=done
set lamphrs [target] =0 lamphrs=0
set vgaoutnetenable [target] =on
=off
vgaoutnetenable=[target]
set usb1source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
set usb2source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
T  T I P
The set usb1source and set usb2source commands are only applicable to SMARTUX60
projectors running DLP firmware version 1.0.0.4 or later.
N  N O T E
The Network and VGAOut setting’s features are off by default. Select on to activate these
features.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
80