Instruction Manual

Important Revision Note: The release version of the Remzibi’s OSD 3DR, has an error on the silk screen
label on the back side of the board: the silkscreen currently reads "-, +, RSSI" when it should be "RSSI, -,
+". This correction is shown above. Please be aware of this before you use the product.
Assembling Remzibi’s OSD 3DR
You will need to cut away some of the spare pins that came with your Remzibi’s OSD 3DR. Cut two sets
of 7 pins and one set of 2 pins from the row of 20 right angle header pins. You will have 4 pins left over.
Save them for another project! You will only need 7 rows from the block of 3x8 right angle header pins,
so you can carefully cut off one row of pins:
Serial Port
Used for GPS
or connecting
to your
computer
I2C port
ADC ports
(“AN3”-“AN5”
& “CURRENT”)
and clock ports
Video In/Out
Battery
Motor
Battery
Used to read
motor battery
voltage
RSSI
Measure
radio signal
strength
+
―
RSSI
Silkscreen
correction for the
release version