Instruction Manual

Powering the Board
Remzibi’s OSD 3DR must be powered externally with 12V. To power your board, just plug your 12V
battery into the PWR +12V pins. The board will not be powered from the computer via the DIY Drones
Remzibi’s OSD 3DR cable.
Unlike with the Original Remzibi’s OSD, the video camera and video transmitter can be powered directly
from the Remzibi’s OSD 3DR board. The video input and output pins include +12V pins which can be
used to power your camera and video transmitter directly from the board.
Connecting Video Equipment
The OSD board is placed between the video camera and the video transmitter on the R/C plane. There
are typically 3 wires that connect these two components. A red wire for power (for example, 5V or
12V), a black wire which is ground and a white wire which is the video signal. Remember that unlike with
the Original Remzibi’s OSD, the video camera and video transmitter can be powered directly from the
Remzibi’s OSD 3DR board, so if your video equipment uses 12V, you do not need to make a custom
cable for powering the camera and video transmitter. If your video equipment requires something other
than 12V, you may need to use a voltage regulator or a separate battery to power it.
Video Input/Output
Battery