Manual

ManualsBrandsA&D ManualsPrinters191

1010

With the printer in the setup menu and with

CONFIGURE [NEXT/OK] CONFIGURE [NEXT/OK]

CONFIGURE [NEXT/OK] as the last item printed, press

OK OK

OK (right side) to access the

CONFIGURE CONFIGURE

CONFIGURE menu. The

following is printed:

OAD DEFOAD DEF

OAD DEF

AULAUL

AUL

TSTS

TS gives you the opportunity to reset the

printer to all default settings (shown below).

Choose

OK OK

OK to do this or

NEXT NEXT

NEXT to go to the next param-

eter. The following is printed:

Baud rate is the next parameter you can set in the

CONFIGURE CONFIGURE

CONFIGURE menu. The complete list of parameters and

their possible values is shown below.

The sample list above shows the current baud rate is

2400. To accept this, press

OK OK

OK (right side) or view the

next baud rate value by pressing

NEXT NEXT

NEXT (left side). Press

OK when the baud rate you want is displayed

Choose from these baud rates;

300, 600, 1200, 2400, 4800, 9600, or 19200

A BITSA BITS

A BITS is the next parameter. Choose the data bit

value the same way baud rate was chosen. Choices are 7

or 8 data bits.

Baud RateBaud Rate

Baud Rate

Data BitsData Bits

Data Bits

Load DefaultsLoad Defaults

Load Defaults

The complete list

of defaults is

shown in the

Default Table at the

end of this manual.