Owner's Manual blood pressure monitor

Section 1: Preparation

Once paired, the Monitor 3 Air will always display the tank

pressure of the cylinder to which the transmitter is

connected, whenever it is in range.

Note: The pairing procedure only needs to performed once,

before the first use. After that, the only time you need to

perform the pairing procedure is when you use a new

transmitter, new computer, or have the battery changed.

Always check the cylinder pressure before every dive.

For best possible reception, it is best to fit the transmitter

on the same side of the regulator first-stage where you will

wear the wrist unit. For example, if you wear the computer

on your left wrist, mount the transmitter on the left side of

the regulator.

Using the Monitor 3 Air Without the

Transmitter

If, for any reason, you are unable to use the transmitter,

you can still use the wrist unit as a dive computer. It will

provide all the normal information found in the MODE,

DEPTH and TIME zones. However, the influence of breath-

ing rate and work load will not be taken into account in the

decompression calculations. The AIR ZONE will remain

blank and you will need to monitor your cylinder pressure

using a conventional gauge.

Checking the Battery Power

You can manually check the battery power of the Monitor 3

Air. While in Ready Mode or Surface Mode, touch contacts

A&D. The word "bat" will be displayed along with the

battery power. Battery power is given as a percentage, with

99% being the highest percentage displayed. Its a good idea

to check the battery power before you start a series of dives.