Owner's Manual blood pressure monitor

Section 2: Diving with the Monitor 3 Air

Preparation for the Dive

Note: The following preparation instructions assume that

the transmitter is installed correctly into your first-stage

regulator (see page 8) and that it is paired with the Monitor

3 Air computer (see page 9).

WARNING: If the Monitor 3 Air transmitter is not

correctly installed or not paired with the computer,

it will not perform properly. If you rely on the

computer in this condition to plan your dive, you

risk serious injury or death.

Switch on the Monitor 3 Air by touching

contacts A and D. Check the display to make

sure all the display elements are lit.

STEP 3

Open the cylinder valve. The transmitter

switches on automatically when it senses

pressure.

STEP 4

Mount the regulator (with transmitter attached)

onto the SCUBA cylinder.

If your cylinder has a reserve valve, commonly

referred to as a “J”-valve, make sure the reserve

lever is in the full open position (lever is pulled

down).

STEP 1

STEP 2