Owner's Manual blood pressure monitor

Section 4: Pre-Dive Planning Mode
45
STEP 3
If you do not want to add any additional surface
time, go to step 4. If you do want to add surface
time, touch contacts A & C. If you add too much
surface time and want to decrease it, touch
contacts A & B.
Increase Time
Note: Surface interval
time increases in 15
minute increments for
the first 6 hours, 30
minute increments
from 6 to 12 hours, and
1-hour increments
after that.
STEP 4
After adding the desired amount of surface
interval time, touch contacts A & D. The word
"run" flashes for a few moments, then the
Monitor starts scrolling from 50 to 200 feet in
10-foot increments. For each depth the com-
puter gives the maximum allowable no-stop time
at that depth.
Decrease Time
Note: If you want to stay
longer than the no-stop
time limit, proceed to
"Planning a Decompres-
sion Dive" on page 46.