Owner's Manual blood pressure monitor

Section 5: Care & Maintenance

Care After the Dive

CAUTION: If the Monitor 3 Air transmitter is not

attached to a first-stage regulator while soaking

(explained below), make sure that water is not

allowed to enter the high pressure inlet. Water

entering the transmitter may cause damage to the

internal components.

After each day of diving, soak the Monitor 3 Air in a warm,

fresh water bath to dissolve salt crystals. To dissolve heavy

salt buildup, use a slightly acidic vinegar/water bath. After

removing the computer from the bath, rinse thoroughly

with fresh water. Towel dry the computer before final

storage. Place the Monitor 3 Air in a cool, dry and protective

case to transport.

The transmitter should be rinsed at the same time the

regulator is rinsed. Make sure the transmitter is attached

to the first-stage. Connect the first-stage to a charged

SCUBA cylinder. Turn on the cylinder valve and submerge

the whole regulator/tank system in a bath of water. By

applying pressure to the regulator, you absolutely prevent

any water from entering the regulator and transmitter.

Annual Dealer Inspections & Factory

Service

Factory service was discontinued in 1997. Please contact

the original manufacturer, Uwatec, at 800-467-2822.