Manual

Replacing the Printing Paper

----

Front View

1, First, turn the power OFF.

Side View

Front of Printer

j] Paper Roli

oi.

Side of Printer

Loosen the screws on the printer cover and

draw out the printer unit.

Peel off the adhesive tape on the printing

paper (PP-137) completely, insert the shaft

provided as an accessory and set the

paper. (Be careful of the Erection of the

paper.)

After setting the paper to the holder, take

out the paper and insert it into the opening

labeled "A" on the printer through the lower

side of the roller, as shown to the left.

With the paper inserted, turn the right knob

of the printer unit in the direction of the

arrow shown to the left; the paper should

come out the front.

!f the paper fails to come out, check for a

bend or fold in the paper. If it is difficult to

insert, fold the top over a few centimeters.

If the ink ribbon needs adjusting turn the

knob of the ink ribbon to give tension to it.

Return the unit to its original position and tighten the screws on the

printer cover.

Note 1: Do not apply excessive force to the printer unit. If normal, it

can be drawn out easily. If it is hard to take out return it once and draw

it out again. The guide may be damaged if excessive force is applied

vertically or horizontally.

Note 2: The printer is made of precision components and could be

damaged if metallic powder, water or other foreign substance get inside

the printer. Also be careful of static electricity when the printer is drawn

out..

If dust and other foreign substance get inside the unit, blow it out with

clean air. If the unit is used in a dusty environment consider using a

dust cover or air purge when not in use.

Note 3: A red mark will be printed approximately 1m before the end

of the roll of paper; replace the paper when you see this mark.

owners-AD-8118A-v.3.a

Page 11