Manual

Applications
Serial Inputs
The serial input can be changed through the RS-232C to current loop by
the slide switch on the rear panel. Select either one depending on the
product being connected. The power for the current loop is supplied by the
receiving side.
When using the RS-232C the following cables are useable:
For current loop (DIN7P-DIN7P) Note 1:
KO : 359- 200
KO : 359- 400
KO : 359- 600
KO : 359- 800
KO : 359-1000
KO : 359-1200
KO : 359-1400
For RS-232C (D1N7P-DSUB25P):
KO
360- 200
Hint: "KO : 359-200" is a 200 cm, or 2 m cable for the current loop.
Notel: When connecting option OP-03 (RS-232C option) from a FV or
FW, use a cable for the current loop.
Set the connected instrument to stream, auto print or manual
print mode. The command mode can not be supported. In
addition, if the standard format input is set through the unit,
inputs are not accepted on rare occasions. Set the unit to
Dump print in such a case.
Connection to an Industrial Scale
The standard format of A&D industrial scales are as follows:
AD-4316 +
AD-4321 A/B +
AD-4322A
AD-4323
AD-4324
AD-4325A
FV series +
FW series +
OP-04
OP-04
(OP-04) *2
(OP-04)
(OP-04)
(OP-04)
OP-03
OP-03
* 1 A unit with "+OP-XX" means that it is necessary to pair this option.
Page 26
owners-AD-8118A-V.3 .a