Company Ltd Instruction manual Blood Pressure Monitor TM-2655/TM-2655P

6. INSTALLING THE PRINTER PAPER

(This chapter is applicable only to the TM-2655P.)

With the power turned on, install the printer paper as follows:

1. Cut the top end of the printer paper with scissors. If the end is

not smooth, it may cause a paper jam or damage the printer

head.

2. Press lightly on the center of the printer cover to open the

cover.

3. Raise the lever located on the right side of the printer. Insert

the printer paper into the paper feed slot as shown. The paper

is fed automatically.

4. Press the PAPER FEED switch to feed the paper by 10 cm.

Confirm that the paper is fed straight. If not, re-install the paper

because it may cause a paper jam.

5. Lower the lever and feed the paper. The paper will be cut

automatically.

6. Close the cover. Press lightly on the center of the printer cover

to secure it in position.

Note

z With high-speed printing, about 700 printings can be

performed. With three-line printing, about 600 printings.

z Replace the printer paper when the red end is reached.

z Use the specified thermal paper, which is sold separately.

Fig.11 Paper installation procedure