Technical data

English 7
Measurements
Measurement With Storing Data
1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2. Press the
START button.
The buzzer sounds and the average blood
pressures and the WHO classification and
last data number are displayed briefly.
When the " 0 " is flashing, the device is
ready for measurement. If the
mark is
displayed, the cuff has some air trapped in
it. Press the exhaust valve button until the
mark is displayed.
3. Pressurize the cuff by squeezing the rubber
bulb.
A pressure bar indicator and the current
pressure are displayed.
Stop squeezing the rubber bulb when the
mark disappears.
Note: If you want to stop inflation at any time,
stop squeezing the rubber bulb and press
the exhaust valve button to expel the air
from the cuff.
4. When inflation is complete, deflation starts
automatically and the buzzer sounds and
the
(heart mark) blinks, indicating that
the measurement is in progress. Once the
pulse is detected, the mark flashes and
the buzzer sounds with each pulse beat.
5. When the measurement is complete, the
buzzer sounds and the
mark is
displayed. The systolic and diastolic
pressure readings and pulse rate are
displayed and stored.
6. Press the exhaust valve button to
completely release air from the cuff.
When a measurement is made with
insufficient pressure, the
mark will be
displayed. Re-pressurize the cuff. Stop
squeezing the rubber bulb when the
mark disappears.
When a measurement is made with an
erratic pulse or in a very noisy