User guide

Installation
Mounting
Fig. 2 Wall mounting bracket
6
A
1. Make sure that the wall can withstand at least twice
the weight of the water heater when completely filled
with water.
2. Before locating the position for installation of the
water heater, make sure that there is sufficient
clearance available for the product. This clearance is
required for easy installation and maintenance. Refer
Fig. 1A or Fig. 1B for minimum clearances required
according to the model.
3. Use a drill bit with diameter of 10 mm to drill 2 holes
at least 90 mm deep in the wall (Fig. 3). The two holes
should be aligned horizontally. The horizontal distance
between the 2 holes is shown in the above table (Fig. 2).
4. Insert the expansion anchors into the holes. Place the wall mounting bracket over
the expansion anchors and tighten the screws on the bracket (Fig. 3).
5. Place the water heater on wall mounting bracket (Fig. 4) using hanger hooks. Tug
downwards on the heater to ensure that the water heater is fixed steadily.
Fig. 3 Installation of
wall mounting bracket
Expansion tube
Hanger
Screw
90
Fig. 4 Inserting the water heater
into mounting bracket
Wall
Water
Heater
1
2
3
Fig. 1A Position for installation
Fig. 1A Applicable for models EWSH 15 and EWSH 25
Ceiling
Wall
RHS
Water heater
400 mm
400 mm
Fig. 1B Position for installation
Fig. 1B Applicable for models EWSH 15 - LHS and EWSH 25 - LHS
Ceiling
Wall
400 mm
400 mm
Water heater
LHS
A (mm)
260
380
Model
EWSH 15
EWSH 15 - LHS
EWSH 25
EWSH 25 - LHS