Manual

ManualsBrandsA.R.I. ManualsWater equipmentD-060HFNS EN

Handeling , Installation , Operation and

Maintenance instructions for

D-060 HF NS Combination Air Valves Non

Slam

A. Installing and Operating the D060 HF-NS

Air valve

B.1. The air valve will be mounted on a riser, connected to the top

of the pipe.

B.2. An isolating valve will be installed below the airvalve.

B.3. Flush the system before installing the air valve to avoid any

dirt or sharp objects getting into the air valve.

B.4. Lift the air valve from the lifting ring by a hoke place

it carfuly on the rubber seal over the shut-off valve.

B.5. Use washers below each bolt & nut that connects the air

valve’s flange to the shut-off valve below.

B.6. The bolts and nuts should be tighten simultanicly (one

Against the other (opposite to him).

The closure tightness of bolts and nuts shall be according

to the standard (Torque) for the bolts and nuts dimention

is used .

Please use ring ranch keys (to be operated by hand) for

closing and opening all bolts of the air valve (inclu. The bolts

at the flage).

A.R.I FLOW CONTROL ACCESSORIES LTD

Summary of content (4 pages)

PAGE 1
Handeling , Installation , Operation and Maintenance instructions for D-060 HF NS Combination Air Valves Non A. Slam Installing and Operating the D060 HF-NS Air valve B.1. The air valve will be mounted on a riser, connected to the top of the pipe. B.2. An isolating valve will be installed below the airvalve. B.3. Flush the system before installing the air valve to avoid any dirt or sharp objects getting into the air valve. B.4.
PAGE 2
B. Maintening the D060 HF-NS Air valve C.1. Maintening the Automatic air valve. C.1.1. Shutoff the isolating valve below the air valve. C.1.2. Unscrew the body (1)of the Automatic air valve (No.22 drawing no. 5292-00-02) from the Base (make sure that the base will not rotate!). C.1.3. Remove the Clamping Stem (3)and the float (4)from the automatiic component and wash the inside of the body, the Clamping Stem, the float, and the Rolling Seal (2),with clean water. C.1.4.
PAGE 3
C.2 Maintening the Kinetic air valve. C.2.1. Unscrew the bolts (8) that connect the valve cover (2) to its body (1). C.2.2. Clean the internals of the following parts part : the body including the groove of the Oring , the screen, the float and the cover with clean water in order to remove coarse grime or accumulated scale. C.2.3. Check that the nozzle seal (4) is in a good shap , means that is not torn and/or not cracked. C.2..4.
PAGE 4
C.3 Maintening the Anti-Shock element. C.3..1. Please check (through the cover) that the flap (18) moves Freely without any distturb in the falp house (17). C.3.2. In case that the flap does not move freely in the flap house, Please act as follows: C.3.3. Unsrew the four domed nuts (12) , take of the screen Cover (6) and the screen (7). C.3.4. Unscrew the nuts (13) of the four threaded rods. C.3..5.Take of the ring K060NS. C.3.6. Pull out the flap of the house. C.3.7.