Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 1 Quick start guide Intended use: smarT.power is a universal charging device for charging (in absence of other charging options) your mobile phone, your TEASI-navigation system or other devices with a 5V (USB) charging capability while you are out and about. Depending on the battery capacity of the device to be charged, it may even be possible to charge or recharge it several times. smarT.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 2 smarT.power is dustproof and waterproof in accordance with standard IP65, which means that smarT.power can be used outdoors, even in heavy rain, for example.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 3 Below we simply refer to external devices that are to be charged as “receivers”, as they receive the charging voltage and current from the “donor” smarT.power. Basic operation: (4) Charging the receiver (e.g. smartphone or TEASI): Press the ON / OFF switch (4) 1x: smarT.power starts to charge the receiver Pressing the ON / OFF switch (4) again stops the charging process.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 4 (6) Battery status indicator: This three-colour LED indicator shows the status using 3 colours, red, yellow and green: 1. smarT.power is operational i.e. smarT.power is operating as a donor. A receiver is being charged or the LED spotlight is switched on. Rapidly flickering red light: less than 5% charge remaining WARNING! Please switch off the smarT.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 5 2. The internal battery of smarT.power is being charged: Flashing red: 1%-30% charged, smarT.power is charging Flashing orange: 31%-50% charged, smarT.power is charging Flashing green: 51%-99% charged, smarT.power is charging Continuous green light: smarT.power is fully charged. The charging process can be stopped. To recharge smarT.power use a standard USB charger with a 5V 1A charging port (e.g.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 6 as soon as possible. If you do this, please indicate that your smarT.power has fallen into water! Never open the device yourself! Lithium batteries are subject to special safety regulations! To clean the device, it is best to use a soft cloth, which should be lightly damp at most. Never use water or a damp cloth to clean the electrical ports (5) and (8)! Do not recharge smarT.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 7 LED spotlight (1): smarT.power bis equipped with a powerful USA CREE LED spotlight with a correspondingly long service life of approx. 5,000 hours. The LED spotlight can be folded out up to an angle of 90°. A mechanical lock prevents an angle of more than 90°. If it is difficult to rotate, you should never attempt to turn it by force. You may have already reached the end stop or there may be something blocking the pivot.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 8 Connecting to a HR 4QF system mount: Push smarT.power onto the 4QF mount from above until smarT.power snaps securely into place. You can attach your smartphone or TEASI case on the other side in the same manner. Make sure that both locking mechanisms have snapped into place securely on both sides. smarT.power is thus mounted between the mount and the mounting case of the smartphone / TEASI almost like the filling in a sandwich.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 9 Connecting the adapters supplied: The following 4 charging adapters for receiver devices are supplied with smarT.power: (1) (Micro USB) (2) (Mini USB) (3) (iPhone 4/4s) (4) (iPhone 5) 1 2 3 4 These allow you to charge or recharge almost all mobile devices on the market (navigation devices, mobile phones, tablet PCs, MP3 players etc.). Each of these 4 adapters can be plugged into the green port for external devices (5).
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 10 If an appropriate adapter (see illustration) is plugged into the port (5) correctly, this connection is waterproof and dustproof. Do not change or plug in the adapter in the rain or, for example on the beach, as water, sand or dirt could get inside. If water or sand/dust penetrates inside, this can lead to short-circuits or mechanical damage. These are not covered by the warranty.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 11 or, B Technical specifications: Input: DC 5V / 1A direct current - maximal permitted 6.5V / 1A direct current Output: DC 5V / 1A direct current. The charging current is regulated according to the device connected. Built-in battery: 5400mAh Li polymer / rechargeable battery Maximum efficiency: 90% (depending on the system, up to approx. 90% of the maximum capacity can be extracted) Luminosity of the high-power LED: Cool white, max.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 12 Included in the delivery: 1 x smarT.power 1 x charging cable with USB connector 1 x charging cable with open ends (e.g. for connecting to a hub dynamo) + = red, – = black 1 x iPhone 4/4S adapter 1 x iPhone 5/5S adapter 1 x micro USB adapter with 90° connector 1 x mini USB adapter 1 x waterproof storage bag for the adapter 1 x this guide Final notes / safety information: 1.
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 13 4. In the event of mechanical damage or breakage of the casing, the device must be sent to the manufacturer for inspection. 5. This device / smarT.power must never be immersed or submerged in water! Warranty / service: You (the consumer) receive a 36 month warranty commencing on the date of purchase. This warranty does not apply to damage caused by improper treatment or external influences (water, dropping, sun, impact or breakage).
