Quick Start Guide

2. The internal battery of smarT.power is being charged:
Flashing red: 1%-30% charged, smarT.power is charging
Flashing orange: 31%-50% charged, smarT.power is charging
Flashing green: 51%-99% charged, smarT.power is charging
Continuous green light: smarT.power is fully charged. The charging process can be
stopped.
To recharge smarT.power use a standard USB charger with a 5V 1A charging port (e.g.
from a smartphone) and the USB charging cable supplied. The cable is plugged into the
charging input (8) (under the rubber cap). A charge cycle takes about 6 hours if the re-
chargeable battery is almost or completely empty.
Waterproof and dustproof in accordance with IP65. What does this mean?
You can use smarT.power even in heavy rain and off-road. smarT.power is appropriately
waterproof and dustproof for these conditions. However, the following requirements must
be observed:
smarT.power must never be immersed or submerged in water! If this happens, for
example as the result of a fall, immediately switch off smarT.power completely, wipe dry
all ports and blow water out of them. Then please send the device to the service center
Manual - SMART power RZ EN_Layout 1 23.01.14 14:50 Seite 5