Quick start guide TL32100/TL32200/TL32250/ TL32300/TL32350 DECT 6.
See pages 2-4 for easy instructions. You must install and charge the battery before using the cordless handset. Install the telephone base close to a telephone wall jack and an electrical outlet not controlled by a wall switch. The telephone base can be placed on a flat surface or vertically mounted on the wall (see Wall mount installation in the user’s manual). For optimum range and better reception, place the telephone base in a central and open location.
Telephone base and charger installation Install the telephone base and charger as shown below. If you subscribe to high-speed Internet service (DSL - digital subscriber line) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters. The telephone base comes ready for tabletop use.
Battery installation and charging Battery installation Install the battery as shown below. . Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label. 2. Insert the supplied battery with the label THIS SIDE UP facing up as indicated. . Align the cover flat against the battery compartment, then slide it upwards until it clicks into place.
Battery installation and charging Battery charging Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging.
Quick reference guide REDIAL/PAUSE DIR/VOLUME Press repeatedly to view the last 20 numbers dialed. Press to scroll up while in menus. While entering numbers, press and hold to insert a dialing pause. Press to increase the listening volume. Press to show directory entries when the handset is not in use. PHONE/FLASH Press to make or answer a call. During a call, press to answer an incoming call when you receive a call waiting alert.
Quick reference guide EQUALIZER During an outside call, intercom call, message or announcement playback, press to change the quality of the audio to best suit your hearing. The > symbol indicates the feature to select. >Play messages Answering sys Main menu Play messages Answering sys Directory Call log Intercom (appears if you have more than one handset) Ringers Settings Website Using menus Press MENU/SELECT to enter the main menu. Press Press DIR or CID to scroll through menu items.
Quick reference guide /HANDSET LOCATOR Press to make handsets beep so you can locate them. Message window Displays the number of messages. During playback, displays the message number currently playing. /PLAY/STOP Press to start or stop message playback. While call screening, press to temporarily turn the call screening on or off. REPEAT After the answering system plays the day and time the current message was received, press to repeat the message currently playing.
Answering system settings - announcement The announcement is the greeting callers hear when calls are answered by the answering system. The telephone has a default announcement, “Hello. Please leave a message after the tone.” You can use this announcement, or record your own announcement. You can record an announcement up to 90 seconds. The system does not record any announcement shorter than two seconds. To play the current announcement: . Press MENU/SELECT when in idle mode. 2.
www.telephones.att.com Audio assist™ is a trademark of Advanced American Telephones. © 2010-2011 Advanced American Telephones. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Advanced American Telephones, San Antonio, TX 78219. Printed in China. Issue 2 AT&T 07/11.
