Owner`s manual

2.4 Installation at the CD Changer Location

In this section you will learn how to install the PXDP in the

factory CD changer location. If your vehicle is equipped with

a factory CD changer you will need to disconnect it from

the factory pre-run harness in order to connect the PXDP

interface. If your vehicle is not equipped with a factory CD

changer, you will need to locate the factory pre-run harness.

This may involve the removal of the; center console, glove

box, or carpeted side panels in the trunk. Please consult

your vehicle’s dealership or a local car audio professional

for instruction or assistance with locating the factory CD

changer connection if necessary.

1. Connect your vehicle speciﬁc Harness to the factory pre-

run CD changer harness in the vehicle.

2. Make any necessary wiring connections on your vehicle

speciﬁc harness. Please see section 2.3 for details on

making these wiring connections.

3. Now that the interface is connected to the radio, you

will need to test the operation of the interface before

permanently running the black iPod docking cable or re-

assembling the dash.

First, connect the black iPod cable to the iPod. The iPod

should indicate that it is being charged. Turn on the factory

radio and press the button that would activate the factory CD

changer to select the iPod. It may take up to three minutes

for the interface to initialize to the radio (this only happens

the very ﬁrst time you select the iPod). Once the iPod has

been selected, press Play on the iPod. You should be able

to hear the music on your iPod through your factory radio.

Now press the “Next Track” button on the radio. The iPod

should change to the next song on the iPod. By pressing

the “Previous Track” button on the radio the iPod should

change to the previous song. With the operation of the

interface conﬁrmed, you may continue with the installation.

If you experience difﬁculties in operation, please see our

troubleshooting chart in section 3.2.