Owner`s manual

11
4. Decide on a convenient location to mount your iPod.
5. Run the docking cable from the interface to the desired
mounting location. Use caution to not cut, pinch, or crimp
the cable during this step. Avoid moving parts, vehicle wiring
harnesses and areas of excessive heat when routing the
cable.
6. Secure the interface in the vehicle using; double sided
tape, Velcro or wire ties. Make sure to check for proper
clearance and avoid moving parts. Take into account the size
of the interface and the wire harness and do not force the
interface and harness into a space that is too tight, damage
to the harness may result.
7. Now that the interface is secured and the docking cable
has been run, you are ready to enjoy your iPod in your
vehicle!
2.5 Installation at the Radio
In this section you will learn how to install the PXDP behind
the radio. If your vehicle is equipped with a factory CD
changer or other external audio source, you will need to
disconnect it from the back of the radio in order to connect
the PXDP interface.
1. Carefully remove the radio from the vehicle. If your radio
uses a Security Code, make sure that you have the code
before unplugging the radio. Some vehicles require the use
of special tools to remove the radio. Please consult your
vehicle’s dealership or a local car audio professional for
instruction or assistance with radio removal if necessary.
2. Make any necessary wiring connections on your vehicle
specific harness. Please see section 2.3 for details on
making these wiring connections.
3. Connect the Vehicle Specific Harness to the CD changer
port on the back of the radio. Be sure to make a firm
connection but do not force it. If there is difficulty making the
connection, please consult the application guide to confirm
your vehicle specific harness selection.