Owner`s manual

4. Now that the interface is connected to the radio, you

will need to test the operation of the interface before

permanently running the black iPod docking cable or re-

assembling the dash.

First, connect the black iPod cable to the iPod. The iPod

should indicate that it is being charged. Turn on the factory

radio and press the button that would activate the factory CD

changer to select the iPod. It may take up to three minutes

for the interface to initialize to the radio (this only happens

the very ﬁrst time you select the iPod). Once the iPod has

been selected, press Play on the iPod. You should be able

to hear the music on your iPod through your factory radio.

Now press the “Next Track” button on the radio. The iPod

should change to the next song on the iPod. By pressing

the “Previous Track” button on the radio the iPod should

change to the previous song. With the operation of the

interface conﬁrmed, you may continue with the installation.

If you experience difﬁculties in operation, please see our

troubleshooting chart in section 3.2.

5. Decide on a convenient location to mount your iPod.

6. Run the docking cable from the interface to the desired

mounting location. Use caution to not cut, pinch, or crimp

the cable during this step. Avoid moving parts, vehicle wiring

harnesses and areas of excessive heat when routing the

cable.

7. Secure the interface in the dash cavity behind the radio

using; double sided tape, Velcro or wire ties. Make sure to

check for proper clearance and avoid moving parts. Take into

account the size of the interface and the wire harness and

do not force the interface and harness into a space that is

too tight, damage to the harness may result.

8. Now that the interface is secured and the docking cable

has been run, you may reinstall the radio and replace any

panels that may have been removed to access the radio.

You are ready to enjoy your iPod in your vehicle!