Owner`s manual

Chapter 1- Getting Started

1.1 Introduction

Thank you for purchasing the PXDP iPod Interface, by

iSimple®. The PXDP is designed to provide endless hours

of listening pleasure through most vehicles’ factory radios.

To ensure that your iPod performs correctly in your car or

truck, we recommend that you read this entire manual before

attempting installation of the PXDP interface.

The PXDP interface will allow you to connect your iPod to

a factory radio that has the ability to control a CD changer.

The PXDP is designed to be used with most iPod Models

featuring the 30 pin docking port.

1.2 Precautions (Important, Please Read)

UPDATING iPod FIRMWARE

For proper operation of the PXDP, your iPod must be

updated with the most recent version of Firmware from

Apple. This is done on your computer. To Update the

software on the iPod go to http://www.apple.com/ipod/

download/. Follow the directions on the website to complete

the download. There is no charge for this update.

PREVENTING DAMAGE TO YOUR VEHICLE OR iPod.

The manufacturer recommends unplugging the iPod when

not in use.To eliminate the risk of an electrical short, we

recommend disconnecting the car battery in most vehicles,

prior to installation except in the following situations:

• Vehicles equipped with on-board navigation should not

have the car’s battery disconnected. Doing so may cause

loss of memory settings. These settings would then have

to be reprogrammed by an authorized car dealer for a fee

to be paid by the vehicle’s owner. For these vehicles, we

recommend extreme caution when handling exposed 12V

power or ground wires/connectors.