Owner`s manual

6
As you consult the application guide, please take a moment
to review our IMPORTANT COMPATIBILITY NOTES listed
with each of the vehicle manfactuers. These notes will
inform you of any issues or circumstances that can affect the
compatibility of our product with your factory audio system
and accessories. Some situations result in the loss of use
of some factory audio players. Please read and understand
these notes before proceeding with the installation.
1.6 Programming the PXDP
Now that you have identified the correct harness and dip-
switch configuration using the application guide, it is now
time to program the interface. To program the interface, set
the dip-switches located on the side of the interface (see
Fig.1 below) to the congfiguration listed for your vehicle in
the application guide. Switches are in their default setting of
“off” in the up position and are turned “on” when switched
down. This programs the PXDP to work with the vehicle
in which it will be installed. The dip-switches MUST be set
before the interface is plugged into the vehicle. Otherwise
the PXDP will not work correctly.
Please Refer to Page 18 for Configuration Settings
PLEASE NOTE: If after installation you experience low
volume from the interface, Dipswitch 6 can be turned on
for a 6Db gain.
12
3
4
5
6
7
8
DIP
ON
Fig.1 Side view of Interface with dip switches