Installation manual

ARRANGING THE COALS
Safety Notice - Please see SAFETY NOTICES
ref. Coal set page 4.
Warning: The coals and the coal matrices are
fragile ensure they are handled carefully.
Ensure location is correct. Do not force the
matrix into position. If the coals and/or the coal
matrices are damaged they must be replaced
with genuine Aarrow replacement sets.
Warning: An incorrect coal layout may cause
soot to build up inside the fire and therefore
invalidate the guarantee.
Step 1 Place the base matrix on the matrix plate
centrally between the end tabs of the location bar.
(Fig 3a)
Fig 3a
Step 2 Place the rear matrix cut out section over
the base matrix and centralise the assembly
between the end tabs of the location bar. Ensure the
rear matrix is pushed back against the location bar.
(Fig 3b)
Fig 3b
Step 3 Locate 2 off end coals each side of the base
matrix. (See underside of coals for hand
identification) (Fig 3c)
Fig 3c
Step 4. Place 3 large coals vertical between the
central cut outs of the base matrix and then lean the
coals back to rest on rear matrix. (Fig 3d and 3e)
Fig 3e
Step 5. Becton 7 only; Place the 2 small coals
each end of the 3 large coals. (Fig3f)
Fig 3f
Becton Bunny & Becton 7 MK2 Gas stoves 7
OPERATING INSTRUCTIONS