Operation Manual

6.53 On/Off, On/Off2, On/Off3, On/Off4 113
6.53 On/Off, On/Off2, On/Off3, On/Off4
The On/Off, On/Off 2, On/Off 3 and On/Off 4 switch modules have respectively
one to four inputs and one to four outputs. Their behavior is very simple: when the
buttons are in the Off position, the output is zero regardless of the input signals and
when the buttons are pushed in the On position, the output signal is the exact copy of
the input signals. The transition between the two states (On/Off ) is smoothed in order
to avoid clicks when turning the switches On or Off.
Typical Use
An On/Off switch can be used as a mute button or to create modulation matrices.
Figure 59: On/Off switch used to mute the output of a VCO module
Note: See also Volume, Slider, Gain, Selector.
6.54 Or
The OR module performs an OR logic operation. The one output of this module is either 1 (true)
or 0 (false) depending on the values sent to the two inputs. To deliver 1 at the output, either one or
the two inputs must receive a value of 1, otherwise the output will deliver a value of 0. This module
has no front panel. The following diagram shows the output value depending on the values in the
two inputs.
Input signals are considered False (0) when smaller than 0.1 Volts and True (1) when greater
than 0.1 Volts.
Input1 Input2 Output
1 1 1
1 0 1
0 1 1
0 0 0
Table 4: Or module output as a function of its inputs.