Operation Manual

2.3 Tutorial 3 Using a Sequencer 39
Figure 19: Tutorial 3, step 1
Step 2: Using a sub-patch
Description
The sub-patch you have just created appears in the Sub-Patch section of the Browser. It can
be used just like any other module, this will enable you to connect it to other modules in the
construction area. In this example, we will connect this sub-patch to a Multi Sequencer module.
Construction
• Choose the New command in the File menu to start another instrument.
• Drag the sub-patch you just created in the construction area.
• Select a Multi Sequencer module in the Sequencers folder and drag it in the construction
area.
• Pull a wire between the fourth output of the Multi Sequencer module (a gate signal) and the
first input of the Sub-patch module.
• Pull a wire between the fifth output of the Sequencer module (a pitch signal) and the second
input of the Sub-patch module.
• Choose a Level and Audio Out module from the In/Out section and a Volume module from
the Envelopes section.
• Pull a wire between the output of the Sub Patch module and the input of the Volume and
another one between the output of the Volume and the inputs of the Level and the Audio
Out.
• Save your patch for step 4.