Operation Manual

2.3 Tutorial 3 Using a Sequencer 40
Figure 20: Tutorial 3, step 2
Playing
You have now connected the sequencer to your synth and are ready to play. In the next step you
will learn to use the Sequencer. You can view the internal connection of the new library module
by right-clicking (PC) or Ctrl+double-click (Mac) on the module in the construction area.
Step 3: Using the Sequencer
Description
In this step we will play with pre-recorded sequences.
• From the Tutorials folder in the Browser, select Tutorial3 and double-click on the Se-
quence1 preset. This will launch the patch in the Player.
Playing
Load presets for the Sequencer module by clicking on the upwards pointing arrow in the lower left
corner of the Sequencer module, this will take you the Multi Sequencer module in the Browser.
You can now select sequences on the keypad of the Multi Sequencer module. You can change
them as you want. The Sequencer is always in loop mode (unless the once button is pressed), so
the sequence keeps repeating itself. When the end of the current loop is reached, the new sequence
will start playing. The speed or tempo of the sequences can be varied with the frequency display
(the upper green window at left) on the panel. Change the settings of the controls of the different
modules and experiment with the different sequences!
Step 4: Programming the Sequencer
Description
The Multi Sequencer module is a very complete 16-step sequencer. You must manually enter each
note to be played and patterns can be up to 16 note (not every step has to play a note, some may