Operation Manual

6.30 Inverter 96
Sub-patches may have between 0 and 12 inputs and 0 and 12 outputs but they must always
have at least one input or output. As soon as an Inlet or Outlet module is included in a patch, the
Tassman Builder will consider that you want to define the current patch as a sub-patch and will save
it as so in the Sub-Patches folder of the Browser. You can then use it just like any other module.
Typical Use
A sub-patch is created with an Inlet or Outlet module or both. The inputs of the sub-patch are
determined by connecting them to an Inlet module. In the example of Figure 24, a stereo-reverb
sub-patch having two inputs and two outputs is created.
Figure 49: A reverb sub-patch.
Note: See also the Outlet (1-12) modules.
6.30 Inverter
The Inverter module has no front panel control. It has one input and one output. It is used to invert
the phase of the input signal. In other words, the output is the input signal multiplied by -1.
Typical Use
Figure 50: Modulation of the cutoff frequency of a filter using an Inverter.