User guide

23/1531-ANF 901 43 C1 2013-01-04

Configuration Manual Cordless Phones DT69X/DT390

5.18 Clear lists when inserted in charger

Note: this feature is applicable for DT692 only.

The phone can be configured to clear lists when placed in a charger. The following lists

will then be cleared:

• Inbox

• Unsent

• Sent

• Call list

• Missed calls

Note: Both call lists and message lists will be cleared.

Using WinPDM/CPDM3 and the "Edit template" feature, the parameter can be found at

Connections > In_Charger > Clear_Lists_In_Charger

in a template or parameter definition file (.def).

The default setting for "Clear list in charger" is "Off". The feature is activated by

changing the parameter value to "On". When the feature is enabled, the lists are

cleared when the phone is placed in the charger.

5.19 Disabling of Homebase GAP Registration

When the feature is disabled, it is not possible to register to a home base.

Using the "Edit template" feature in WinPDM/CPDM3, the parameter is normally found

at:

Systems > Home_Base_Subscription.

The parameter shall be set to "Enable" for registration on a new base station. The

default value is "Disable".

5.20 Require Encrypted Base Station

The phone can be configured to establish calls via encrypted base stations only. This is

used to avoid snooping in the telephony network.

Requirements:

• The encryption is enabled in the base station. See corresponding manual for the

base station.

• If Aastra´s BS/IPBS base station is used, the software version must be 3.1.x or

greater.

• The phone software version must be 2.9.7 or greater.

Using the "Edit template" feature in WinPDM, the parameter can be found at

Systems > Encryption required.

When the parameter is set to "Yes", it is only possible to establish calls via encrypted

base stations. The default value is "No".

5.21 Base Station Location

Note: This feature is only applicable for DT692 and with CPDM3