User guide

23/1531-ANF 901 43 C1 2013-01-04

Configuration Manual Cordless Phones DT69X/DT390

An approximate location of the telephone is possible to sent along with an alarm. The

telephone evaluates the field strength ratio of the individual radio Base Stations and

sends the best-rated Base Station ID to indicate an approximate location of the

telephone.

In addition, a system can also request the Base Station ID regardless if an alarm is sent

or not. See 5.22 Poll Location.

1 Select "Location".

2 In the Base station positioning drop-down list, select "On" to enable the

positioning.

Note: The standby time for the telephone will be lower when Base station location is

activated.

5.22 Poll Location

Note: This feature is only applicable for DT692 and with CPDM3

A system/application can request a location of a telephone. When location of the

telephone is requested, the telephone sends its approximate location (Base Station

positioning must be enabled, see 5.21 Base Station Location). The telephone sends

the best-rated Base Station ID together with the time since it was received.

5.23 Site Survey Tool

This feature is included in DT690and DT 692 only.

See User Guide, Site Survey Tool.

5.24 Alarm Settings

Note: This feature is applicable for DT692 only.

The parameters described in this chapter are applicable for all alarm types (that is

Push-button Alarm and Test Alarm). See also 5.24.1 Push Button Alarm for additional

parameter settings.

In a template or Number in PDM/CPDM3, the parameters for activation are found at:

Alarm > Common

Parameters in the current version are:

• Stored alarm data

Determines which data to be sent along with an alarm.

• Password protect ALS

Determines if a password is required to turn off the ALS

• Number for automatic call after alarm

Determines which number the telephone automatically shall call after an alarm has

been sent.