Product manual

:HOGLQJHTXLSPHQW

7HFKQLFDO'HVFULSWLRQ

Teknbeskr_eng.fm

5HSODFHPHQW5HSDLU

When refitting the drive motor in the event of replacement or repair of the motor

the motor shaft must be centered in relation to the two feed rollers, using the

centering device (art. no. 500 332-001) in order to avoid wear as regards teeth and

bearings.

Dismantling

 Remove the two drive rollers.

 Dismount the driving gear and the three Allen screws. The drive motor can

now be lifted out.

The remounting is performed in the reverse order, excepted the use of the

centering device.

&RQWURODQGLQGLFDWLQJGHYLFHVRQWKHZLUHIHHGXQLW

 WIRE FEED switch for manual wire feed.

 RESET switch for resetting the gun collision sensor.

 AIR connection to the welding gun.

 Connection IN for water (blue hose). Applies to water cooled guns.

 Connection OUT for water (red hose). Applies to water cooled guns.

 Euro-socket for the welding gun.

Figure 9 Side of the wire feed unit.

j500084