Product manual

:HOGLQJHTXLSPHQW
,QVWDOODWLRQ
Installation_eng.fm 21
,QVWDOODWLRQ
&RQILJXUDWLRQRI:HOGLQJ(TXLSPHQW
)OH[LEOH,QWHUIDFH/ ARCITEC (LRB/LRC)
On delivery the equipment is configured according to applicable configuration data
which are stored on the disk that comes with the delivery. The data can be read and
modified by way of the robot programming unit. See chapter .
For the definition of configuration data, see “Appendix 1” on page 59.
The following files on the installation disk contain configuration data for the weld-
ing equipment:
53%B)KS(FIJ Explanation: Configuration data for power source
RPB 320/420/520 and wire feed unit
A140E/A314E/A324E-L_PIB
(6$%0,*B)KS(FIJ Explanation: Configuration data for power source
ESABMIG 400/500t and wire feed unit
A140E/A314E/A324E-L_PIB
Lrb_FhpE.cfg Explanation: Configuration data for power source
LRB/LRC and wire feed unit
A140E/A314E/A324E-L_PIB
Laf_FhpE.cfg Explanation: Configuration data for power source
LAF and wire feed unit A140E/A314E/A324E-L_PIB
0,//B)KS(FIJ Explanation: Configuration data for power source
Miller Delta Weld Series and
A140E/A314E/A324E-L_PIB
In case these configuration data must be reloaded, proceed in one of the following
ways:
• 5RERRWWKHURERW:The original configuration will be restored.
• /RDGLQJXVLQJWKHSURJUDPPLQJXQLWin those cases where individual
parameters need to be changed compared to the original configuration.
• /RDGLQJDQHZFRQILJXUDWLRQILOH (EIO:CFG) Executed by way of the
robot instruction 6\VWHP3DUDPHWHUV?)LOH?$GGRU5HSODFH3DUDPHWHUV?
ILOHFIJSe “Appendix 5” on page 69.
,PSRUWDQW
As the disk is unique for the equipment supplied it should be stored in a safe place.
The program number indicated on the disk corresponds to the configuration in
question, and should be referred to in case of service matters regarding the function
of the welding equipment.