Service manual

ABM International, Inc. Series 1018, 1022 & 1026 V7.0
Model: Innova Users Guide
Proprietary information of ABM INTERNATIONAL, Inc. furnished for customer use only.
No other uses are authorized without prior written permission of
ABM INTERNATIONAL, INC.
5
SECTION 2.0 – Machine Setup
The Innova ships fully tested ready to operate. As a result, this manual provides a section on machine setup so that
you can install the machine. Please read this manual in its entirety and follow all ABM instructions, especially the
inspections. Total setup time, excluding frame assembly, will take approximately 1 hour.
SETUP INSTRUCTIONS:
INSPECTION #1: Upon receipt of the machine, check to ensure that there is no visible damage. Figure 0.1 and
the front cover of this manual are enough for this inspection. Note: that some components may be in different
locations depending on the version of the machine.
Determine the location in your facility for the quilting machine. Once a final position has been determined for the
machine, plug it into your 3 prong AC outlet (NOTE: Machine is voltage specific 110-125 VAC 60Hz or 220-240
VAC 50/60Hz). The machine comes wired with a voltage specific plug according to the original machine shipment
destination, and should be plugged directly into the wall receptacle or a surge protector (not supplied). ABM does
not recommend the use of any type of extension cord to power the machine. As with any machine, power should be
run properly through approved ducting with proper termination. Coil any excess cable and wire tie it to the table of
the machine, which will reduce the risk of a tripping hazard.
WARNING: RISK OF ELECTRICAL SHOCK. MAKE SURE THE OUTLET
BEING USED FOR THE INNOVA HAS A WORKING EARTH GROUND
CONNECTION. IF YOU ARE UNSURE, HAVE A QUALIFIED ELECTRICIAN
CHECK THE CIRCUIT. FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY OR DEATH.
INSPECTION #2: Will confirm that the electronics of the Innova long arm quilting machine are functioning
properly.
WARNING: ELECTRICAL SHOCK HAZARD. NEVER ATTEMPT TO WORK
ON OR OPERATE THE MACHINE WHILE THE ELECTRICAL COVERS ARE
REMOVED. WHENEVER REMOVING THE ELECTRICAL COVERS PLEASE
BE CERTAIN TO TURN-OFF THE MACHINE AND UNPLUG THE POWER
RECEPTICAL.
Upon power up, the PLC should power up and show up on the LCD. If this does not occur, check for incoming
voltage at the outlet.
WARNING – WHEN OPERATING THE MACHINE, YOU MUST ENSURE THAT THERE
ARE NO LOOSE ITEMS SUCH AS TOOLS, FOOD, DRINKS, ETC. ON THE MACHINE AND
THAT ALL PERSONNEL ARE CLEAR OF THE MACHINE.