Installation Owner manual

The diagram below shows the correct usage of soldered

distributors when connecting more than one detector to an

alarm zone:

As mentioned above, the alarm centre evaluates the

alarm zones via the existing current flow. Most alarm

detectors are normally closed, which means that the

detectors interrupt the alarm zone in the event of an

alarm. The detectors are called NC (normally closed)

detectors and are connected as follows (the CCT jumper

must be removed):

Sometimes it is necessary to combine several alarm

contacts in a zone. Connect the contacts serially.

NO (normally open) contacts (e.g., for panic buttons)

cannot be connected to this alarm centre.

Verteiler

NC-Alarmkontakt

(z.B. Öffnungsmelder)

nschlusskabel zur Zentrale

NC alarm contact

(e.g. contact switch

Connection cable to alarm centre

NC alarm contact