User manual

English

5. Installation

5.1. Pairing the camera and the monitor

To connect a camera with the monitor, proceed as follows:

5. Connect the camera and the monitor to the power supply units.

6. In the monitor menu, select “Camera settings”, then the required camera. Now select the "Pair

camera" option and press the menu button.

7. Then press the PAIRING button on the camera cable. The green link LED starts to flash.

8. Once the connection is established, the link LED on the camera illuminates for 2 seconds and

then goes out. The message "Pairing successful" appears on the monitor.

Important:

Please note that the connection can take up to 60 seconds.

5.2. Mounting the camera

Use the camera mount to help you find a suitable installation location. Now mark the drill holes on the

surface, and drill the holes. Insert the screw anchors supplied before you attach the mount with the

screws.

Important:

Before you begin installing, make sure that the wireless transmission range is adequate at the

site of the required installation.

To do this, first screw in the antenna supplied.