Instructions / Assembly

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

CERTIFICATION: cULus DRY NO.

29000LEDDLP/29001LEDDLP/29002LEDDLP

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEW ACCESS LIGHTING FIXTURE

VER: 19.12.1

Please ensure that the fitting is cool and

switched off before replacing the bulb.

DO NOT use bulbs that exceed the

maximum wattage, stated on caution label.

CAUTION

PREPARE THE FIXTURE AND CONNECT THE

WIRES

If there is an existing fixture remove it. Determine the

desired hanging height and secure the 3pcs rods to the

canopy and fixture. Insert the fixture wire through the

rods to the canopy.

ATTACH MOUNTING BRACKET AND

MAKE

WIRE CONNECTION

Expose the supply wires from the J-box. Install the

mounting bracket to the J-Box with the supplied screws.

Gently pull the supply wires through the hole in the

mounting bracket. Connect the black supply wire to

the black fixture wire. Secure with the supplied wire nuts.

Connect the white supply wire to the white fixture wire.

Secure with the supplied wire nuts. Attach the green

J-Box wire around green hexagonal head screw or

connect it to the green supply grounding wire of the

fixture. Secure all wires with electrical tape

(not supplied). Tuck all wires carefully into the J-Box.

Place the canopy up to the mounting bracket, align the

side holes and secure with the supplied screws.

INSERT THE BULB

Insert the bulb.

DO NOT EXCEED THE MAXIMUM WATTAGE AS

STATED ON THE WARNING LABEL