Installation Sheet

IMPORTANT

Before assembling your ACCESS LIGHTING fixture, please make sure that

you carefully read through these instruction sheets. Consider having

your fixture installed by a qualified licensed electrician.

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wires from the outlet box.

Tighten 2 sets of rods to the canopy and fixture.

Determine the desired length of your fixture; loosen the

knurled thumb nuts, located on the rods of the fixture. Once

the desired length has been determined tighten the knurled

thumb nuts so that the rods remain secured.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Crossbar

•

Mounting Hardware

•

LED

COLLECTION

CERTIFICATION: UL DRY NO. 63064LEDD

63064LEDD

APPLICATION MODEL NO.

Pendant Fixture SLEEK

PAGE 1
CERTIFICATION: UL DRY NO. 63064LEDD INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur.
PAGE 2
CERTIFICATION: UL DRY NO. 63064LEDD MAKE WIRE CONNECTIONS WITH DRIVER Mount the crossbar to the J-box with the supplied screws. 2 Gently pull the supply wires through the hole in the crossbar. Connect the black supply wire to the black driver input wire. Secure with the supplied wire nut. Connect the white supply wire to the white driver input wire. Secure with the supplied wire nut. Either wrap the green wire around one of the protruding screws or connect it to the supply ground wire.