Switch User Manual

EtherHub-16 Quick Start Guide

EMI Warning

FCC Class A Certification

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received,including interference that may cause

undesired operation.

Warning: This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instruction manual, may cause

interference to radio communications. It has been tested and found to comply with the

limits for a Class A computing device pursuant to Subpart B of Part 15 of FCC Rules,

which are designed to provide reasonable protection against such interference when

operated in a commercial environment. Operation of this equipment in a residential area

is likely to cause interference, in which case the user, at his own expense, will be

required to take whatever measures are required to correct the interference.

You may use unshielded or shielded twisted-pair (100Ω STP or UTP) for RJ-45 connections.

Warnings

1. Wear an anti-static wrist strap or take other suitable measures to prevent

electrostatic discharge whenever handling this equipment.

2. When connecting this hub to a power outlet, connect the field ground lead on the tri-

pole power plug to a valid earth ground line to prevent electrical hazards.

3. The connectors are not for telephone system use.

Les raccordeurs ne sont pas utilisé pour le système téléphonique!

Note:

In order to maintain compliance with the limits of a Class B digital device,

Accton requires that you use a quality interface cable when connecting to this

device. Changes or modifications not expressly approved by Accton could

void the user’s authority to operate this equipment. Suggested cable type is:

Twisted-pair for RJ-45 connections: 10BASE-T

This Ethernet (50 ohm) for BNC connections: 10BASE2

Thick Ethernet (D-type) for AUI connections: 10BASE5 or 10BASE-F