CheetahAccess Wireless Gateway Quick Installation Guide

Installation
2-2
Although access speed to the Internet is determined by the modem type connected
to your CheetahAccess Wireless Gateway, data passing between devices
connected to your local area network can run up to 100 Mbps over the Fast Ethernet
ports.
The CheetahAccess Wireless Gateway includes an LED display on the front panel
for system power and port indications that simplifies installation and network
troubleshooting. It also provides three RJ-45 LAN ports, one RJ-45 WAN port, one
RS-232 serial port, one parallel printer port, as well as two antennas on the rear
panel.
The following figure shows the components of the CheetahAccess Wireless Gateway:
Figure 2-1. Front and Rear Panels
Item Description
LEDs Power, WLAN, WAN and LAN port status indicators.
(See “Verify Port Status” on page 2-8.)
Wireless
Antennas
Dual antennas provide optimal reception by dynamically choosing the best antenna
for each client.
Reset
Button
Use this button to reset the power and restore the default factory settings.
Printer Port Parallel port (25-pins, D-type, female). Connect the shared printer to this port.
COM Port Serial port (9-pins, D-type, male). Connect your ISDN TA or 56K analog modem to
this port.
Printer Port
Console Port
LAN Ports
WAN Port
Power Input