CheetahAccess Wireless Gateway Quick Installation Guide

Installation
2-8
Note: When connecting to the WAN port, use 100-ohm Category 3, 4 or 5 shielded or
unshielded twisted-pair cable with RJ-45 connectors at both ends for all
connections.
Connect the CheetahAccess
™ Wireless Gateway to a Printer
If you connect a printer to the CheetahAccess Wireless Gateway, all the computer
users connected to your LAN can have access to the printer. Connect a standard
parallel printer cable to the Printer port on the CheetahAccess Wireless Gateway,
and configure the printer server as described on page 6-1.
Connecting the Power Adapter
Plug the power adapter into the power socket on the CheetahAccess Wireless
Gateway, and the other end into a power outlet. Check the indicator marked Power
on the front panel to be sure it is on. If the power i
ndicator does not light up, refer to
Troubleshooting in Appendix A
.
Verify Port Status
Check the power and port indicators as shown in the following table .
LED Condition Status
Power
(Green)
On CheetahAccess Wireless Gateway is receiving power.
WLAN
(Green)
On
The CheetahAccess Wireless Gateway has established a valid
wireless connection
.
WAN
(Green)
On The WAN port has established a valid network connection.
LAN
Link
(Green)
On The indicated LAN port has established a valid network
connection.
Activity
(Amber)
Flashing The indicated LAN port is transmitting or receiving traffic.