CheetahAccess Wireless Gateway Quick Installation Guide

Networking and Client Services
4-5
Use this menu to restrict management access based on a specific password. You
must enter a password to access the configuration options provided by the menus.
By default, there is no password. So, please assign a password to the Administrator
as soon as possible, and store it in a safe place.
Passwords can contain from 3–12 alphanumeric characters, and are case-sensitive.
Note:
If your password is lost, or you cannot gain access to the management interface,
press the Reset button on the front panel (holding it down for at least five
seconds) to restore the factory defaults.
Set Time Zone
Set the time zone for the CheetahAccess Wireless Gateway. This information is used
for log entries and client filtering.
LAN Gateway and DHCP Settings
Configure the gateway address of the CheetahAccess Wireless Gateway. To
dynamically assign the IP address for client PCs, enable the DHCP Server, set the
lease time, and then specify the address range. Also remember to configure all of
your client PCs for dynamic address allocation.